YAMADEN – SHT – 130

Ideal for the detection of high temperature powder particles. It realizes the best class heavy load and high sensitivity.

To achieve a best-in-class heavy load and high sensitivity for high temperature level switch

  • Ideal for powder and granular level detection at high temperature (250 ℃ compatible).
  • High class sensitivity (apparent specific gravity 0.02) and leading edge load (1 kN) are realized.
  • It is possible to detect most powders, grains, and lumps.
    ■ Detection of various powders, pellets and chips.
    ■ Ideal for detection of incineration ash, resins, clinker (cement raw material), etc.

The following two kinds of lineup are prepared.

  • SHT-130: probe extension type
Need more information?

Please contact +6221-5467618, +6221-54212399 or email [email protected]

Achievements

Use  Level detection (level switch)
Measured object  Powder / granule / mass
Detailed measurement item  Powder particles (resin powder, resin pellets, cement, casting sand, wheat flour, iron oxide powder, etc.) / powder particles with a small specific gravity (toner, silica, film, powdered milk etc.) / powder , Resins etc.) / mass (rock, stone, gravel, etc.)
Contact / non-contact  contact
Measuring method  Vibration type
Explosion proof  None (non-explosion-proof)
Tank size  Medium size (drum size)
Mounting position  Vertical (from the top) / Horizontal (from the side) / Diagonally (from the side)
Detailed measurement environment  Measurement of powder / granular material of high temperature / high pressure / medium size / large tank / raw material level control / boiler · high temperature / high pressure tank / strict environment such as temperature, pressure, difficult place to maintain and check

Specification

Amplifier section

Power supply AC / DC 20 to 250 V
Power consumption 3VA
Operating ambient temperature -20 ° C to + 70 ° C
output Configuration: 1 C, capacity: AC 1250 VA DC 80 W
Maximum detection sensitivity 0.02
Case material Aluminum die-cast
Protection grade IP 67
Wiring port M20 × 1.5 (with cable gland)
Maximum switching voltage AC 250 V
Maximum switching current 5 A

Sensor part

Material SUS 304
Allowable temperature -20 ° C to + 250 ° C
Allowable pressure 1 MPa
Allowable load
L dimension Min 221 mm max 2 m
option 2 point alarm output (DPDT), wire extraction port 2 holes, probe buff finish

Connection

Size R1 1/2
Material SUS 304
option Various flanges

Terminal box

Material Aluminum die-cast
Wiring port M20 × 1.5
Protection grade IP 67